Where are high-water-use zones most appropriately used?
a. in remote, rarely used areas
b. in high-profile areas
c. inside the home
d. near naturally occurring water sources
B
in high-profile areas
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. All bathtubs shall have at least 1 1/2 inch waste and overflow. 2. Local health departments commonly have different or more restrictive requirements than national plumbing codes. 3. Water closet compartments shall be no fewer than 60 inches wide and 30 inches in length. 4. All sinks have a minimum drain size requirement of 1 1/2 inches and require a strainer or cross piece to catch or retain waste products. 5. Water temperature concerns regarding bidets have recently been addressed by codes mandating an ASSE 1070 device set to a maximum temperature of 135ºF.
Two technicians are discussing MAP sensors. Technician A says that the MAP sensor should be replaced if anything comes out of the sensor when the vacuum hose is removed from the sensor. Technician B says that the injector pulse width should increase when vacuum to the MAP sensor is increased. Who is right?
A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B
Design an op amp circuit such that v? = 4v? + 6v? – 3v? – 5v?
Let all the resistors be in the range of 20 to 200 k?.
Technician A says power brakes were developed because of increased vehicle weight and increased speed capabilities. Technician B says most vehicles with disc brakes systems operate with power assist. Which technician is correct?
A) Technician A only B) Technician B only C) Both Technicians A and B D) Neither Technician A nor B