In refrigeration and air conditioning, loads are normally wired:

A) Either in series or in parallel with each other. B) In series with each other.
C) In parallel with each other. D) In parallel with the switches controlling them.


C

Trades & Technology

You might also like to view...

The three factors that determine the amount of capacitance of a capacitor include the area of the plates, the distance between the plates and _______?

A. the reluctance of the material between the plates B. the number of amp-turns in the dielectric constant C. the dielectric constant of the material between the plates D. the CEMF of the capacitance

Trades & Technology

A vehicle creeps faster than normal when the engine is cold. What is the most likely cause?

A) A defective stator one -way clutch B) Incorrect ATF C) A TCC stuck in the applied position D) Normal operation

Trades & Technology

In a split-system air-to-air heat pump, the coil that absorbs heat in the heating mode is referred to as the _____.

a. outdoor coil b. indoor coil c. heating coil d. heat sink

Trades & Technology

What is the state of the refrigerant as it leaves the accumulator?

A. Sub cooled liquid B. Superheated vapor C. Superheated liquid D. Sub cooled vapor

Trades & Technology