Answer the following statement(s) true (T) or false (F)
1. Schematics in industry are often small.
2. Schematics in industry may contain several pages.
3. It is common for high voltage disconnect switches to have four contacts for the switch.
4. All manufacturers use the same numbering and notation system for schematics.
5. Push buttons, HOA switches, pilot lights, and so on are generally located on a control terminal where an operator has access to them.
1 False.
2. True
3. False
4. False
5 True
You might also like to view...
When a sharp corner has only a slight relief, it is referred to as:
a. round b. break corner c. fillet d. runout
Which of the following is not generally found in a zone thermostat of a VVT system that uses a monitor thermostat?
a. Time clock b. Schedule programming c. A display d. A bus connection
If a technician needed 5/8" ACR for an installation and was located near only a plumbing supply house, what size and type of pipe should he ask for?
A. 5/8" ACR. B. 1/2" PVC. C. 1/2" ID Copper. D. 5/8" PVC.
What is the most abundant element on earth?
A) Nitrogen B) Oxygen C) Water D) Hydrogen