When removing an inertia brake from an Eaton AMT, which of the following must be done first?
A. remove the transmission from the chassis
B. disconnect the vehicle battery bank
C. remove the transmission air/filter regulator
D. remove the transmission ECU
Answer: C
You might also like to view...
When electricity can directly power drive motors, what is the highest rate of thermal efficiency in current vehicles?
A. 40% B. 60% C. 80% D. 100%
A ____________________ is a combination of seed from cultivars of the same species
Fill in the blank(s) with correct word
A typical IAT or ECT sensor reads about 3000 ohms when tested using a DMM. This resistance represents a temperature of about ________
A) 70°F (20°C) B) 120°F (50°C) C) -40°F (-40°C) D) 284°F (140°C)
Technician A says that aluminum pulling studs should be removed using a twisting motion. Technician B says that aluminum pulling studs should be cut and filed or ground flush. Who is correct?
A. Technician A only B. Technician B only C. Both Technicians A and B D. Neither Technician A nor B