What procedure should you observe when planning the pulling process?
What will be an ideal response?
When planning the pulling process, you should observe the following procedure:
| 1. | Determine the direction of the pulls. |
| 2. | Find out how to repair the damage in the reverse (first-in, last-out) sequence from which it occurred during the collision. |
| 3. | Plan the pulling sequence with the pulls in the opposite direction from how the damage was caused. |
| 4. | Find correct attachment points of the pulling clamps. |
| 5. | Estimate the number of pulls required to correct the damage. |
| 6. | Determine which parts must be removed to make the pulls. |
You might also like to view...
The Editor’s Report in the November 2003 issue of Technometrics provides the following information regarding the length of time taken to review articles that were submitted for publication during the year 2002. A few articles took longer than 9 months to review, these are omitted from the table.
a. Construct a histogram for these data.
b. Which class interval contains the median review time?
c. Which class interval contains the first quartile of the review times?
d. Which class interval contains the third quartile of the review times?
Determine v? and v? in the circuit in Fig. 3.71.
 FIGURE 1.png)
What diagnostic equipment is usually needed to diagnose faults or relearn the electric power steering system?
A) A breakout box B) Factory of factory-level scan tool C) Special electronic diagnostic equipment designed to test each specific system D) A 12-volt test light
The movable contact of the normally open held closed switch is drawn below the stationary contact.
Answer the following statement true (T) or false (F)