What type of weld is required based on the symbol shown in Figure 4?

a. Bevel groove with removable backing

b. V-groove with removable backing

c. V-groove with a plug weld on the other side of the joint

d. V-groove with permanent backing




d. V-groove with permanent backing

Trades & Technology

You might also like to view...

While using a scanner to diagnose the IAC valve, if the value is at or near ____________________ the PCM is trying to reduce the idle speed.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

A compound planetary gear set contains two complete planetary gear sets.

Answer the following statement true (T) or false (F)

Trades & Technology

Technician A says that the lower the Bin number is, the cleaner. Technician B says that SULEV has cleaner standards than ULEV. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B

Trades & Technology

A(n) ____ is used to connect a lead from a component or connect a wire from an off-board component.

A. paper doll B. jumper C. autorouter D. pad

Trades & Technology