Before removing the piston and rod assembly from the cylinder block, you should do all of these, EXCEPT ________
A) Install rod bolt protectors
B) Make sure the rods are marked to their respective cylinders
C) Notch the top of the piston for identification
D) Remove the cylinder ridge with a ridge reamer
C
You might also like to view...
A ____ gearset uses two sun gears, two sets of planetary pinions connected to a single carrier, and a ring gear.
A. partial non-hunting B. Ravigneaux C. non-hunting D. hunting
Does pressure applied to the soil surface cause compaction?
Indicate by YES (Y) or NO (N).
Technician A says that most manufacture's use stand-alone electrical systems. Technician B says that in a networked system a fault in one component may cause several symptoms. Who is correct?
A. Technician A only B. Technician B only C. Both Technician A and B D. Neither Technician A nor B
Which of the following cables should include a yellow color-coded conductor?
a. Two-conductor cable b. Three-conductor cable c. Four-conductor cable d. Five-conductor cable