The major bearing(s) used with a clutch assembly is (are) the ________
A) Release bearing that is mounted at the front of the transmission
B) Pilot bearing that supports the end of the transmission input shaft
C) Both A and B
D) Neither A nor B
C
You might also like to view...
Find distances A, B, C and D.
1. A = 2. B = 3. C = 4. D =
Cost per mmBtu of steam from a district heating plant is characterized by which of the following?
A) More than the cost of steam produced on site due to capital investment for the plant. B) Less than the cost of steam produced on site due to higher efficiency. C) Approximately equal to the cost of stream produced on site since fuel costs are equal.
Technician Asays modules on the Media Oriented System Transport (MOST) data bus use an LED, photodiode, and a MOST transceiver to communicate with light signals. Technician B says the Media Oriented System Transport (MOST) system uses fiber optics to transmit data at an extremely fast rate. Who is correct?
A. Technician A only B. Technician B only C. Both Technician A and B D. Neither Technician A nor B
A full oil tank holds 290 gallons of #2 fuel oil. During 5 months, the amounts of fuel oil used are: 8 gallons, 24 gallons, 32 gallons, 91 gallons, and 105 gallons. How many gallons of fuel oil are left in the tank?
Fill in the blank(s) with the appropriate word(s).