The hole locations of the block in the accompanying figure are checked by placing the block on a surface plate and indicating the bottom of each hole using a height gage with an indicator attachment. Determine the height gage settings from the bottom of the part to the bottom of hole 2.
What will be an ideal response?
radius of hole 2 = 0.258/2 = 0.129A + B = 1.008 + 0.640 = 1.648distance to bottom of hole 2 = 1.648 - 0.129 = 1.519Therefore, the main scale setting is 1.500 to 1.525 and the vernier scale setting is 19.
You might also like to view...
Magnetic leakage in a transformer causes a decrease in _____ when the transformer is loaded
a. primary voltage b. secondary voltage c. secondary current d. impedance
What is the danger of wet corn gluten when fed to hogs?
What will be an ideal response?
Units that cannot be measured in base units and require more than one measurement are called:
A) Customary units. B) Volume. C) BTUs. D) Derived units.
Use Data Sheet 5 and 7.Mixed number Example: 2-1/3Put a dash between the whole number and the fraction.Simple Fraction Example: 2/3
1" copper pipe is divided into two equal segments.c-c = 50 inches long1" copper, 90° ell1" copper, teeFind the end-to-end measure of pipe B.
Fill in the blank(s) with the appropriate word(s).