There may be discrepancies between the written specifications and the working drawings because _____

a. the specifications were amended and the drawings were not
b. they refer to different parts of the project
c. specifications are only used by the engineer and architect
d. specifications are no longer needed once the drawings are prepared


a

Trades & Technology

You might also like to view...

Which of the following improper operations does not pose a hazard of turbine shutdown?

A. Steam leaks B. High-discharge steam pressure C. Failure to maintain sufficient inlet steam pressure D. Running a turbine at a speed above or below the normal operating conditions

Trades & Technology

Discharge all capacitors with a(n) ____________________ ohm, four-watt resistor before touching the terminals.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

Technician A says that the diameter of a bolt is the same as the wrench size used to remove or install the fastener. Technician B says that the length is measured from the top of the head of the bolt to the end of the bolt. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B

Trades & Technology

The lightly constructed 45-degree angle projection line is used to represent visual rays.

Answer the following statement true (T) or false (F)

Trades & Technology