In the FEA process, what is the final step before analysis can be performed?
A. applying constraints
B. meshing
C. applying loads
D. creating the model geometry
Answer: B
You might also like to view...
Which of the following is a correct statement regarding fiberglass ductboard?
a. Fiberglass ductboard can withstand significantly higher pressure than metal duct. b. Common duct tape is the perfect material for closing fiberglass ductboard joints. c. Fiberglass ductboard is usually cut will high-speed saws. d. Fiberglass ductboard can be used to insulate metal duct.
When performing arc welding on the rear of a truck chassis, where should the ground clamp be fixed?
A. On the front bumper B. On the battery ground post C. On the battery positive post D. As close to the weld area as possible
Which converters must be monitored by the PCM if a V design engine is equipped with two primary (manifold) catalytic converters and one secondary (downstream) catalytic converter?
What will be an ideal response?
?The lines in a section view used to show where the material is cut, and in some cases to identify the type of material, are called:
A. ?cutting lines B. ?section lines C. ?object lines D. ?hidden lines