Which of the following is NOT one of these assumptions?
The equation:
is frequently applied to a nozzle. Several assumptions are incorporated into the derivation of this equation. Which of the following is NOT one of these assumptions?
A. The system is operating at steady state.
B. The system is adiabatic.
C. The potential energies of the entering and exiting streams are equal to each other.
D. The velocity of the entering stream is negligible.
E. All of the above are necessary assumptions for the derivation of this equation.
A. Incorrect. If the system were not at steady state, time derivatives or differences would appear.
B. Incorrect. If the system were not adiabatic, a heat term (Qor Q ?) would appear.
C. Incorrect. If potential energies were significantly different, this would be a huge nozzle and we would see terms incorporating
gravitational acceleration.
D. Incorrect. There is no v_in^2 term present.
E. Correct.
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. Starters that are intended to protect motors that operate on 240 volts should contain four load contacts 2. Some motors can draw up to 600 percent of rated full load current during starting. 3. Manual push button line voltage starters are manufactured with two or three line voltage contacts. 4. Integral horsepower manual starters with low voltage release will restart automatically after a power failure without being reset. 5. Any heat source can cause an overload to trip.
With the ignition off and the key out of the ignition, what should happen if a technician uses a screwdriver to gently push on the throttle plate in an attempt to open the valve?
A) The throttle should move, and then spring back to the home position when released. B) The throttle should move closed, but not open further than the default position. C) Nothing. The throttle should be kept from moving by the motor, which is not energized with the key off. D) The throttle should move and stay where it is moved and not go back unless moved back.
_____________________ is an electrical force that creates current to flow into a closed circuit.
Fill in the blank(s) with the appropriate word(s).
Compare and contrast smart and standard temperature transmitters.
What will be an ideal response?