How do you use pinch weld clamps to anchor a unibody vehicle?
What will be an ideal response?
Raise the vehicle off the rack a few inches with an air jack or hydraulic jack. Then position four pinch weld clamps under the outer corners of the center section of the vehicle. Lower the vehicle down into the clamps, then tighten the clamps' bolts onto the pinch weld flanges. Also tighten the bolts, securing the anchor clamps to the rack or bench.
You might also like to view...
Produce a timeline of five events mentioned in this chapter that revolutionized biotechnology.
What will be an ideal response?
When installing an oil-fired furnace in a confined space with a firing rate of 100,000 Btuh, what is the minimum free air opening required if the combustion air vents are directly communicating with the outside?
A) 100,000/1,000 = 100 sq in for each grille B) 100,000/5,000 = 20 sq in for each grille C) 100,000/4,000 = 25 sq in for each grille D) 100,000/2,000 = 50 sq in for each grille
The channel from a space probe to earth has a bandwidth B = 106 Hz and a channel capacity C = 0.8 x 107 bps. The signal-to-noise ratio ?S 2 /?N 2 equals ______.
Fill in the blank(s) with the appropriate word(s).
Which of the following CANNOT be measured using a feeler gauge?
A) Piston ring gap B) Connecting rod side clearance C) Piston ring side clearance D) Valve guide clearance