The part of a spool valve where pressure is applied to cause the valve movement is called the ________.
A) Land
B) Valley
C) Bore
D) Face
D) Face
You might also like to view...
Explain the following message: “Wildcard” type output detected - an estimate has been made but actual results may vary due to the large variances in different output card types.
What will be an ideal response?
The ___________________ of electrode movement is dependent on the time required for the molten weld pool to start cooling.
Fill in the blank(s) with the appropriate word(s).
The following statements are all correct EXCEPT ________
A) OBD-II vehicles require monitoring of the EGR system B) The MIL will be turned on after the second failure C) Many vehicles use the MAP sensor to monitor EGR operation D) Linear EGR systems require exhaust backpressure
Technician A says visible streaks of catalyst or hardener left in the plastic when applying it can cause staining problems. Technician B says most plastic filler manufacturers recommend a ratio of approximately 2 percent hardener to the total plastic batch. Who is correct?
A. Technician A only B. Technician B only C. Both Technicians A and B D. Neither Technician A nor B