When removing and replacing a drive pinion seal, what should be marked before removing the pinion nut?

A) Pinion flange
B) Pinion shaft
C) Pinion nut
D) All of the above


D) All of the above

Trades & Technology

You might also like to view...

How much pipe remains in the scrap pile, in inches?

The inventory of a scrap pile is as follows: Channel iron, 87” Plate steel, 147” Key stock, 45” Pipe, 69” Flat iron strap, 208” A pipe support is welded using the following materials from the scrap pile: Channel iron, 61” Plate steel, 106” Key stock, 39” Pipe, 22” Flat iron strap, 189”

Trades & Technology

What is the name of the tool in the figure above?

a. Dividers b. Pistol grip bander c. Sheet metal edger d. Sheet metal jacking shears

Trades & Technology

Voltages of 600V or more are _____.

a. considered low b. not hazardous c. three times more likely to kill than those under 600V d. almost ten times more likely to kill than those under 600V

Trades & Technology

If a tape recorder's output voltage increases and decreases when you shake the recorder, a possible problem might be ________

A) a loose circular magnet around the speaker's voice coil B) an open capacitor C) an open circuit in the speaker D) too high a source voltage

Trades & Technology