The idea that all tax measures should start in the House was made to appease
A. the least populated states.
B. western states.
C. eastern states.
D. the industrialists.
E. the larger states with the most people.
Answer: E
You might also like to view...
When free cooling operation is not practical but the system is operating in an occupied mode, an economizer damper will be in its _____.
a. fully open position b. fully closed position c. half open position d. minimum position
An Australian steel company, ASM International, claims that a savings of 40% of the cost of stainless steel threaded bar can be achieved by replacing machined threads with precision weld depositions. A U.S. manufacturer of rock bolts and grout-in-fittings plans to purchase the equipment. A mechanical engineer with the company has prepared the following estimates for additional costs and savings over the next 4 years (16 quarters). Costs decrease for some time, then increase rapidly as the equipment ages. Savings peak at $80,000 for some quarters, but then decrease as expected competition takes its toll. The U.S. manufacturer president is not sure of the time frame to plan for the use of this new technology. The decision, in part, rests upon the rate of return achievable as the
years of use progress. In the past, projects must return at least 24% per year to be retained.
(a) Determine the expected rate of return per quarter for 2 years (8 quarters) and beyond using a spreadsheet.
(b) Plot i* versus quarter to graphically illustrate your results.
(c) Make a recommendation on the number of years to use the technology to economic advantage.
 FIGURE 1.png)
The Lincoln air spring system uses a ________ to turn the system off for servicing
A) Shut-off switch B) Ground link C) Pressure sensor D) Fused disconnect jumper
Relay coils and the contacts they operate are not shown in the same place on a schematic diagram because:
A) There is not enough room to draw them in the same place. B) Schematic diagrams typically only show where to connect the power wiring. C) The coil and contacts are located in different places in the unit. D) Components are placed by their function in the circuit, not their actual physical location.