What will occur when the full moon is on the ecliptic?

A) a total lunar eclipse
B) a total solar eclipse
C) a partial lunar eclipse if the Moon is at perigee
D) an annular lunar eclipse
E) a partial solar eclipse


A

Physics & Space Science

You might also like to view...

An attractive method of energy conservation in industrial settings is to utilize waste heat from largescale power generating equipment. In one such scheme, the exhaust gases from the diesel engine of an industrial power generator are channeled through a cross- flow, compact, waste-heat recovery boiler to produce process steam. In one such heat exchanger, a finned tube bundle is configured with tubes of 2.5 cm outer diameter that are arranged in a staggered equilateral- triangular array with tube center-to-center pitch of 7.5 cm. Engine exhaust gas (thermal properties of which are taken to be the same as those for air) at 400°C is in cross-flow over the tube bank with a free stream velocity of 2.0 m/s. In order to enhance the gas-side convective heat transfer, the tubes have thin circular

fins on their outer surface and the finned surface extension ratio ?=1.15. Due to the steam generation process inside the tubes, their outer surface temperature is 175°C. If there are 10 rows of tubes in the flow direction (NL = 10), calculate the average heat transfer coefficient and pressure drop for the gas flow stream.

GIVEN

FIND
The average heat transfer coefficient (c h) and pressure drop in gas flow stream.
ASSUMPTIONS
Steady state
Tube wall temperature is uniform and constant
SKETCH

PROPERTIES AND CONSTANTS

Physics & Space Science

The frequency of the second hand on a clock is

A) 1 hertz. B) 1/60 hertz. C) 60 hertz.

Physics & Space Science

Jadeen says that you can increase the resistance of a copper wire by hammering the wire to make it narrower and longer. Arnell says that you can increase its resistance by heating the wire. Which one, if either, is correct, and why?

a. Arnell, because the conductivity of the wire increases when it is heated. b. Arnell, because the conductivity of the wire decreases when it is heated. c. Jadeen, because the conductivity of a wire is directly proportional to its area and inversely proportional to its length. d. Jadeen, because the conductivity of a copper wire does not increase when it is hammered. e. Both are correct because (b) and (d) are both correct.

Physics & Space Science

You push on a block on frictionless ice with a force of 8 N, causing it to accelerate at 2 m/s2 . The mass of the block is

a. 2 kg b. 4 kg c. 8 kg d. 16 kg e. 6 kg

Physics & Space Science