Head gasket installation is being discussed. Technician A says that the surface finish of the cylinder head or block deck is very important for proper sealing to occur. Technician B says that if "front" is marked on a head gasket, the mark should be installed near the accessory belt end of the engine. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
C
You might also like to view...
What does gauge refer to when discussing sheet metal?
What will be an ideal response?
The term "STUF" is an acronym that includes various cross sections used in cold-formed steel construction. Explain what STUF stands for.
What will be an ideal response?
A TP sensor is what type of sensor?
A) Potentiometer B) Rheostat C) Voltage generating D) Piezoelectric
Two technicians are discussing loosening a stuck bleeder valve. Technician A says to use a 6-point wrench and simply pull on the wrench until it loosens. Technician B says that a shock is usually necessary to loosen a stuck bleeder valve. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician