Which of the following is the battery manufacturer's recommended method of removing the surface charge from a recently charged lead-acid battery?
A. crank engine 15 seconds, wait 15 minutes
B. turn on all of the vehicle lights
C. leave it for 24 hours
D. load at 300 amps for 15 seconds
Answer: D
You might also like to view...
Building control circuit wiring that is both powered and controlled by the fire alarm system is governed by _____.
a. NEC Article 725 b. NEC Article 760 c. NEC Article 770 d. NEC Article 800
Which type of pipe measurement is shown in the figure above?
a. End-to-end b. End-to-center c. End-to-face d. End-to-throat
The face reinforcement of a V-groove weld with backing using 1/4" aluminum plate should not exceed
_____. a. 1/16" (1.6 mm) b. 3/32" (2.4 mm) c. 1/8" (3.2 mm) d. 1/4" (6.4 mm)
The closely spaced tees connecting a secondary circuit to the primary circuit are ____ when air is being purged from the system.
a. counterproductive b. instrumental c. essential d. irrelevant