Once you have powered up the system after a repair, what are some simple tests you can perform to check operation?

What will be an ideal response?


Once you verify the system is ready, place it in manual and move each axis to
insure proper operation. If you have a simple program, such as a homing program
or alignment check program, try running one of those to see how the robot
responds. If the robot stopped at a specific point in a program before repairs, load

Trades & Technology

You might also like to view...

A complete plot plan is necessary before local planning and zoning authorities will issue a building permit.

Answer the following statement true (T) or false (F)

Trades & Technology

On some headers, evenly spaced ____ marks appear in the horizontal and vertical directions outside the border. This helps readers of the drawing locate areas on the sheet where specific features can be found.

A. border B. header C. title block D. location grid

Trades & Technology

The Harvard architecture used in DSPs has

A) no address bus. B) no control bus. C) two memories. D) two CPUs.

Trades & Technology

?What is NOT a typical operating mode for an antifreeze-protected solar combisystem?

A. ?solar collecting mode B. ?water heating mode C. ?space heating mode D. ?discharge mode

Trades & Technology