A circle divided into twelve equal parts makes each part 15° (180° ÷ 12 = 15°).
Answer the following statement true (T) or false (F)
False
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. In certain cases, the function of a part may require locating and orienting coaxial diameters at RFS. If the location and orientation of coaxial diameters are being controlled and a tolerance of position at RFS is applied to the coaxial diameters, bonus tolerance is allowed. 2. In certain cases, the function of a part may require locating and orienting coaxial diameters at RFS. If the location and orientation of coaxial diameters are being controlled and a tolerance of position at RFS is applied to the coaxial diameters, Rule #1 applies to both diameters. 3. In certain cases, the function of a part may require that a feature size be located and oriented at MMC. If the location and orientation of a hole is being controlled relative to the outside surfaces of the part and a position tolerance at MMC is applied to the hole, the surface of the hole must not violate the virtual condition boundary. 4. A coordinate measuring machine (CMM) is a precision five-axis machine used to collect and analyze surface points from a part to verify the geometric requirements (size, location, orientation, and form) of part features. 5. A standard touch probe CMM uses scales and transducers to determine precisely where the X, Y, and Z coordinates of the probe are, relative to the machine origin.
Los aislantes de espuma rígida DEBEN guardarse:
a. en el suelo. b. al aire libre. c. en cajas de cartón. d. en un lugar separado del suelo y cubierto.
When troubleshooting the cause of low oil pressure readings on a dash gauge, which of the following should be done first?
A. rebuild the oil pump B. replace the piston oil control rings C. check with a master gauge D. reset the pressure relief valve
What are the two main issues encountered in residential applications?
What will be an ideal response?