Determine the allowance for a hole dimension of 1.325 
and a shaft dimension of 1.345 
What will be an ideal response?
-.03
Trades & Technology
You might also like to view...
How and why could a vehicle fail an OBD test but pass a tailpipe emissions test?
What will be an ideal response?
Trades & Technology
The most common problem with chain drives is that the chains are not checked and ____________________ often enough.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology
When dealing with accident vehicles in the upright position, the two main stabilization concerns are to prevent the vehicle from moving horizontally and:
A. vertically B. forward C. backward D. to the side.
Trades & Technology
When an overhang is needed on the gable end, it can be built as part of the gable-end ____.
A. joint B. wall C. beam D. truss
Trades & Technology