New tie rods are being installed. Technician A says to tighten the retaining nuts to specification and then loosen, if needed, to align the cotter pin hole. Technician B says to tighten farther to align the cotter key hole. Which technician is correct?

A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B


B

Trades & Technology

You might also like to view...

What improper operation can cause hunting?

A) Loss of casing and/or line insulation B) Allowing turbine to run at critical speeds C) Allowing "wet steam" or condensate into the turbine D) Having a turbine governor that is toggling the speed above and below normal operating set point

Trades & Technology

Las grapas deben colocarse a 1/4 de pulgada (0,64 cm) del borde del traslapo y a _____.

a. 9 pulgadas (22,86 cm) entre centros b. 2 pulgadas (5,08 cm) entre centros c. 4 pulgadas (10,16 cm) entre centros d. 6 pulgadas (15,24 cm) entre centros

Trades & Technology

Los adhesivos a base de silicato de sodio _____.

a. pueden utilizarse en casi todas las aplicaciones de aislamiento b. suelen usarse sólo con aislamiento de tuberías de silicato de calcio c. suelen rociarse. d. son a base de solvente.

Trades & Technology

How many 1 K × 4 chips would be required to produce an 8 K × 16 module?

A) 16 B) 64 C) 32 D) 8

Trades & Technology