When replacing a damaged crown and pinion gearset, the damaged pinion cone (PC) variation number was +2, and the new PC variation number is specified as -5. If the original shim pack thickness measured 0.030-inch (0.76 mm), what should the new shim pack thickness be?
A. .033-inch (0.84 mm)
B. .037-inch (0.94 mm)
C. .023-inch (0.58 mm)
D. .027-inch (0.69 mm)
Answer: C
You might also like to view...
A floor in a WLF building that supports a non-load-bearing wall generally requires no additional strengthening or stiffening when
A) the wall runs perpendicular to floor joists. B) the wall runs parallel to floor joists.
Write a program to compute the Fourier coefficients (up to the 10th harmonic) of the square wave in Table 17.3 with A = 10 and T = 2.
 figure 3.png)
 FIGURE 4.png)
 ANSWER.png)
Which of the following is the closest to the outside diameter on a gear tooth?
A. dedendum B. addendum C. root D. pitch line
Technician A says that all steering defects should be considered OOS and the vehicle deadlined until the condition is repaired. Technician B says that excessive toe-in may cause some accelerated tire wear but should not require a vehicle to be OOS deadlined. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B