When joining rigid fiberboard duct modules, the end flaps are secured with _____.

a. 1-inch staples approximately 2-1/4 inches on center
b. 1-inch outward clinching staples approximately 2 inches on center
c. 1/2-inch outward clinching staples approximately 2 inches on center
d. 1/2-inch stainless steel staples approximately 2-1/2 inches on center


c. 1/2-inch outward clinching staples approximately 2 inches on center

Trades & Technology

You might also like to view...

La distancia a la que un soporte superior se eleva verticalmente por cada pie de distancia entre travesaño y cumbrera recibe el nombre de _____.

a. flecha b. pendiente c. flecha unitaria d. proyección

Trades & Technology

Blackwater Spring and Metal utilizes the same computerized spring forming machinery in its U.S. and Malaysian plants. The first cost was $750,000 with S = $150,000 after n = 10 years. MACRS depreciation with n = 5 years is applied in the United States and standard SL depreciation with n = 10 years is used by the Malaysian facility. (a) If the equipment is sold after 6 years for $100,000, calculate the over- or under-depreciation amounts for each method. (b) Use a spreadsheet to plot the book values for both methods on a single graph.

What will be an ideal response?

Trades & Technology

There are two general categories of production: (i) mass production and (ii) ____ production.

A. computer B. sequential C. refined D. custom

Trades & Technology

Find the signal power of the discrete-time function, 4 sinc (n) * [n].

What will be an ideal response?

Trades & Technology