The drafter must decide which angles to use when drawing what plan?

A. isometric
B. baseline
C. outside limits


Answer: A

Trades & Technology

You might also like to view...

The walls are cast on a casting bed of concrete slab-on-ground, specially constructed for casting the panels. After all wall panels are erected in their intended locations, the casting bed is broken, and the broken concrete recycled at the site or sent away for other uses.What are form liners, as used for casting of tilt-up wall panels?

What will be an ideal response?

Trades & Technology

Driveline vibrations due to a bent or out of balance drive shaft on a rear-wheel drive vehicle usually produce a vibration that is ________.

A) Felt in the seat or all over the vehicle B) Felt in the steering wheel C) Seen as a vibrating dash or hood D) Felt by the rear passengers only

Trades & Technology

Which of the following is an HID ballast category?

a. Autoranging circuit b. Constant wattage autotransformer c. Inverted d. Dual-coil

Trades & Technology

Which of the following conditions are NOT produced by an effective control system?

A) Constant load B) The desired transient response C) Steady-state error reduction D) Stability

Trades & Technology