A(n) ____ view uses a centerline instead of a cutting plane to indicate where a section has been taken and rotated 90°.

A. full section
B. revolved section
C. partial section
D. inverted section


Answer: B

Trades & Technology

You might also like to view...

Answer the following statement(s) true (T) or false (F)

1. Electromechanical devices are used to provide interlocking methods and sequencing control. 2. Solid-state starters are available in ranges up to several hundred horsepower. 3. Power-saving modules are available that detect idling or low-power periods of operation. 4. Every function in solid-state starting units is illuminated with electronic LEDs. 5. The energy-saving option, including a microcomputer, is activated before the motor is up to speed.

Trades & Technology

Shade cloth is used to

What will be an ideal response?

Trades & Technology

Which of the following statements is true about installation of exterior doors?

a. A single bead of caulk should be applied both before and after installation. b. The nails used to hold the door shut for shipment should be removed after installation. c. Doors are installed after the building wrap is applied d. Doors are installed before the sheathing

Trades & Technology

The bead width should not be more than ____ times the rod diameter.

A. two B. three C. four D. five

Trades & Technology