Which statement best describes the action of a NAND gate latch?
A) The SET and CLEAR inputs are normally HIGH with one or the other input pulsed LOW to change the outputs.
B) The SET input is normally LOW, the CLEAR input is normally HIGH, the SET input is pulsed HIGH to change the outputs.
C) The SET input is normally HIGH, the CLEAR input is normally LOW, the CLEAR input is pulsed LOW to change the outputs.
D) The SET and CLEAR inputs are normally LOW with one or the other pulsed LOW to change the outputs.
A
You might also like to view...
Field marking of service equipment shall include the _____.
a. time of installation b. date fault current calculations performed c. identification of phase wires d. location of disconnecting means
Plastic pipe typically uses _____.
a. the OD sizing standard b. the IPS sizing standard c. the CTS sizing standard d. a unique sizing standard
This is the part size as measured after production.
a. actual size b. allowance c. basic dimension d. feature
A clunk noise from the drive line may be the result of excessive rear differential backlash
Indicate whether the statement is true or false