Rule 1 of ASME Y14.5 states that the limits of size of a regular feature of size controls form, such as straightness, flatness, circularity, and cylindricity. Briefly explain what this means.

What will be an ideal response?


This means that the form of the feature is dependent on the limits of size.

Trades & Technology

You might also like to view...

When a motor must be started and stopped from more than one location, ____.

a. any number of start and stop buttons may be connected b. the number of start and stop buttons that may be connected varies with its size c. the number of start and stop buttons that may be connected varies with its rating d. two to four start and stop buttons may be connected

Trades & Technology

The correct location for the pads when hoisting or jacking the vehicle can often be found in the ________.

A) Shop manual B) Owner's manual B) Owner's manual C) Service manual D) All of the above D) All of the above

Trades & Technology

What is used in some cubed-ice machines to separate the ice into single cubes?

a. Motorized auger b. Chopper assembly c. Knife assembly d. Electric wire grid

Trades & Technology

One of the biggest reasons why big projects don't get done on time is _______

A) Starting on them too early B) Not breaking the project down into small parts C) Notifying outside partners far in advance D) They are impossible to get done

Trades & Technology