To reduce the chance of repeating a mistake while taping, you should _____
a. measure only once
b. never retape a distance
c. measure again in the reverse direction
d. ask another person to also measure the distance
c
You might also like to view...
Usually the computer will control an actuator by the use of low-side drivers that complete the output device's path to ground through a MOV.
Answer the following statement true (T) or false (F)
Use an approximate analysis of the continuous truss in Figure P13.11 to determine the reactions at A and B. Also evaluate the forces in bars a, b, c, and d. Given: P = 9 kN.
Technician A says that most digital and analog (needle-type) dash gauges use variable resistance sensors. Technician B says that permanent-magnet (PM) generators produce an AC signal and are used for vehicle speed and wheel speed sensors. Who is right?
A) A only B) B only C) Both A and B D) Neither A nor B
When representing structural members in CADD, use the ____ command to assign lines to the proper layers.
A. ?CHANGE B. ?FILLET C. ?PROPERTIES D. ?TRIM