The clamping load on a fastener is known as ____________________.

Fill in the blank(s) with the appropriate word(s).


preload

Trades & Technology

You might also like to view...

Figure 1 shows the electrical symbol for a(n) _____.



a. diac
b. NPN transistor
c. PNP transistor
d. SRC

Trades & Technology

Technician A says that a proper U-joint inspection can be done with the driveshaft in place on the vehicle. Technician B says that you must remove the driveshaft to properly inspect the U-joints. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

What is the maximum value possible out of a binary counter which has four flip-flops?

A) 3 B) 7 C) 15 D) 16

Trades & Technology

The subsequent problems deal with the circuit below where B1 and B2 are NC buttons used to define the digital signal A:If buttons B1 and B2 are both left up, digital signal A will be

A. uncertain B. 0 C. 1

Trades & Technology