Rough lumber is sold by the ____________________

Fill in the blank(s) with the appropriate word(s).


ANS: board foot

Trades & Technology

You might also like to view...

A technician is diagnosing a J1939 communication problem. The following measurements were obtained using a DMM voltmeter at the 9-pin diagnostic connector: CAN + to CAN -3VCAN + to ground2.5VCAN - to ground2.5VWhat do these readings indicate?

A. CAN + is not shorted to CAN -. B. CAN + is not shorted to ground. C. CAN - is not shorted to ground. D. All of the above.

Trades & Technology

Dynamic braking for a DC motor is very effective, but the braking effect becomes weaker as the armature slows down.

Answer the following statement true (T) or false (F)

Trades & Technology

Too slow a cutting speed results in ____.

A. the top edge of the plate being melted or rounded off B. an incomplete cut C. gouges in the side of the cut D. the sides of the kerf being slightly dished

Trades & Technology

In ratio control, the reference flowrate is referred to as controlled flow.

Answer the following statement true (T) or false (F)

Trades & Technology