The minimum cut when machining a drum should be ______
A) 0.020 inch B) 0.002 inch C) 0.0005 inch D) 0.600 inch
B
You might also like to view...
While having a discussion, Technician A says that a coolant position sensor attached to the throttle body on the air inlet senses how many degrees the throttle plate is open. Technician B says that an air charge temperature sensor senses how many degrees the throttle plate is open. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
The timing components are being inspected on a chain system with composite sprockets. The sprockets are very worn and are missing teeth. What should be removed, inspected, and cleaned due to the missing teeth?
What will be an ideal response?
The right-side and left-side isometric base lines each form an angle of ____ with the horizontal.
A. 15° B. 30° C. 60° D. 90°
The test report specifies the test pressure and how long it must be maintained for hydrostatic testing. If it does
not, the test pressure must be at least _____ times the maximum design pressure of the installation. a. one and one-half b. two c. two and one-half d. three