The limits of accuracy on the dimensions given on a drawing are called ____.
A. bounds
B. limits
C. extents
D. tolerances
Answer: D
You might also like to view...
The subsequent problems deal with the switched RC circuit below. Assume that the capacitor has no charge to begin with, and assume that VA and VB are constant dc voltages.
Immediately after the switch is closed (i.e., the circuit is not in steady state yet), what is the correct expression for VR, given the polarity shown?
A. VB ? VA B. 0 C. VA ? VB D. VA E. VB
Runlevel ____ is multiuser mode enabling graphical access via X Window.
A. 2 B. 3 C. 4 D. 5
Computer operator is a career you can obtain with an associate's degree.
Answer the following statement true (T) or false (F)
A modern hydronic heating system typically
A) Heats using low pressure steam B) Heats by circulating hot water through a closed system of piping C) Uses water to cool the condenser of a water to air heat pump D) Heats both the house and the domestic hot water