A system of numbers along the top and bottom margins and letters along the left and right margins is called:
A. road map
B. zoning
C. mapping
D. margin identification
E. none of the above
Answer: B
You might also like to view...
What is the difference between an insurance broker and an insurance company?
What will be an ideal response?
Two technicians are discussing what could be the cause of slow cranking and excessive current draw. Technician A says that an engine mechanical fault could be the cause. Technician B says that the starter motor could be binding or defective. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
What mark is placed on an engine block or other cast engine components for identification?
A) Casting number B) VIN number C) Both A and B D) Neither A nor B
Problem 1.C5
A load P is supported as shown by two wooden members of uniform rectangular cross section that are joined by a simple glued scarf splice. (a) Denoting by ?U and ?U, respectively, the ultimate strength of the joint in tension and in shear, write a computer program which, for given values of a, b, P, ?U, and ?U, expressed in either SI or U.S. customary units, and for values of ? from 5 to 85° at 5° intervals, can calculate (i) the normal stress in the joint, (ii) the shearing stress in the joint, (iii) the factor of safety relative to failure in tension, (iv) the factor of safety relative to failure in shear, and (v) the over¬all factor of safety for the glued joint. (b) Apply this program, using the dimensions and loading of the members of Probs. 1.29 and 1.31, knowing that ?U = 150 psi and ?U = 214 psi for the glue used in Prob. 1.29 and that ?U = 1.26 MPa and ?U = 1.50 MPa for the glue used in Prob. 1.31. (c) Verify in each of these two cases that the shearing stress is maximum for ? = 45°.