The casting in the accompanying figure shows seven tapped holes, A-G. The number of threads is determined by dividing the depth of the thread by the thread pitch. Find the number of threads in hole D. All dimensions are in inches.
A. 3
B. 4
C. 6
D. 7
Answer: D
You might also like to view...
What type of solids handling equipment is used to move material using pressured gas flow from one point to another in a continuous stream?
A. Flow inducer B. Live bottom C. Bucket elevator D. Pneumatic conveyors
Near-azeotropic refrigerants are technically _____.
a. HFCs b. HCFCs c. zeotropes d. compoun
Which of the following does NOT apply to the phosphorus index?
a. Quantifies potential phosphorus hazards on lands b. Dictates amounts growers may use c. Identifies sites with a higher risk of phosphorus movement d. Will devise corrective plans
The factors to be considered in motor and coupling alignment are:
A. parallel (step) misalignment and end-float. B. angular misalignment and end float. C. parallel (step) misalignment, angular misalignment and end-float. D. none of the above.