Which of the following operations could not be used to transform a 3D solid cone into a cylinder?
a. Changing the geometry in the Properties palette
b. Rotate faces
c. Grip editing
d. Taper faces
B
You might also like to view...
The smoothest finish on a flange face is the _____.
a. concentric serrated b. phonographic serrated c. raised face d. coldwater finish
Name the geometric tolerance that is characterized by any given cross section taken perpendicular to the axis of a cylinder or cone, or through the common center of a sphere.
What will be an ideal response?
At what pressure range does the technician valve off the vacuum pump when evacuating to a deep vacuum?
A. 200 to 100 microns. B. 300 to 100 microns. C. 300 to 200 microns. D. 500 to 300 microns.
When two pieces of metal are welded end-to-end and forces are applied inwardly from each end, the pieces
and their weld are being _____. a. twisted b. sheared c. torqued d. compressed