What is a brick without core holes referred to in the masonry industry as solid brick or core-less brick?

What will be an ideal response?


Neither of the two. It is called 100% solid brick.

Trades & Technology

You might also like to view...

Power produced at the crankshaft with only the alternator and water pump drawing power is called _____.

A. gross horsepower B. indicated horsepower C. brake horsepower D. raw horsepower

Trades & Technology

A split system's data plate is useful because:

A) The detailed procedure for charging a new split system can be found on it. B) The factory charge is shown on the data plate. C) It always shows how much refrigerant to add or subtract. D) It provides instructions for proper evacuation of the refrigeration system.

Trades & Technology

An electric defrost cycle is accomplished by:

A) Through normal use from customers opening and closing the doors. B) Shutting off the compressor and bypassing hot gas to the evaporator. C) Leaving the case fans operating and shutting off the compressor. D) Shutting off the compressor and energizing electric defrost heaters.

Trades & Technology

While checking the alignment, you find that the straight edge lines up properly on both sides of the sheaves and touches at all four points. After rotating one of the sheaves, you now find that the straight edge contacts only two of the four points. Most likely:

A. A shaft is bent. B. The shafts are not parallel. C. The driver should be shimmed up. D. None of the above answers is correct.

Trades & Technology