Technician A says that the top mounting nut for a rear shock absorber is often located inside the vehicle. Technician B says that shocks, struts, and springs should always be replaced in axle sets. Which technician is correct?
A) Technician A only B) Technician B only
C) Both technicians A and B D) Neither technician A nor B
C
You might also like to view...
The minimum current required to actuate a device is called the ____ current, and is determined by the applied voltage.
a. pull-out b. pull-in c. drop-out d. drop-in
Which of the following is a disadvantage of a solid rear axle?
A) Side to side shock transference B) Increased proportion of unsprung weight C) Reduced tire adhesion D) All of these are disadvantages of a solid rear axle
A measured voltage of 0 V across the resistor in a parallel RL circuit would indicate:
A) an short in the inductor. B) a blown fuse. C) an open in the resistor. D) either A or B.
The component marked 1 in Figure 1 is a(n) _____.
a. overload contact
b. melting-alloy heater assembly
c. load terminal
d. reset terminal