In a schematic diagram, the load is typically located at the bottom or right side of the drawing.

Answer the following statement true (T) or false (F)


True

Trades & Technology

You might also like to view...

Explain how cross-referencing is used to organize and locate views in a set of drawings.

What will be an ideal response?

Trades & Technology

When a fastener is torqued to specification, approximately how much of the twisting force is required to overcome thread friction?

A. 10% B. 25% C. 50% D. 90%

Trades & Technology

Answer the following statement(s) true (T) or false (F)

1. All electrochemical batteries have three major parts: an anode, a cathode, and an electrolyte. 2. All hybrids that have an electric motor inside the transmission have at least two. 3. BMW’s X6 hybrid uses the same engine and transmission as a BMW 7 series hybrid. 4. The Hyundai Sonata Hybrid uses BAS and ISAD systems. 5. All fuel cell vehicles have regenerative braking and 12-volt auxiliary systems.

Trades & Technology

Earthquakes are one of the three types of loads that buildings must support by providing load paths through the structure and back down to the ground.

Answer the following statement true (T) or false (F)

Trades & Technology