Dimensions that require tolerances different from the general tolerances given in the title block must be specified on the dimension.
Answer the following statement true (T) or false (F)
True
You might also like to view...
A ____ is an overcurrent protection device that opens a circuit where the fusible link is melted away by the extreme heat caused by an overcurrent.
a. circuit b. circuit breaker c. fuse d. fuse breaker
What class of electrical hazard classifications is used to identify gases, vapors, and liquids that can be present in explosive or ignitable mixtures?
A. Class I B. Class II C. Class III D. Class IV
When a 12-volt test light is touched into a harness connector for the blower motor circuit it lights. Following the harness toward the blower motor, the next connector is probed with no light. What does this indicate??
A. ?Nothing is wrong B. ?An open load C. ?An open before the first connector D. ?An open circuit between the two connectors
Replacing stainless steel or galvanized fasteners with plain carbon steel fasteners can create a rust stain issue on the outside of the nacelle.
Answer the following statement true (T) or false (F)