How are blink codes cleared from a CM-813 module?
A. Cycling the ignition switch 1 second on 1 second off for four consecutive cycles
B. Removing the negative ground cable from the vehicle battery
C. Self-clearing depending on how persistent the fault is
D. Both A and C are methods of clearing fault codes
Answer: D
You might also like to view...
?What can be done to protect the contact tube tip from damage?
A. ?Use a high temperature insulating tape to protect the tip. B. ?Use a slightly larger size contact tube tip for the wire size. C. ?Spray the contact tube with WD-40 so the wire will feed smoother. D. ?Recess it inside of the nozzle.
Rabbits can produce young 30 days after breeding and raise four to five litters per year consisting of up to ____________________ young per litter.
Fill in the blank(s) with the appropriate word(s).
Most porosity is caused by _____ or _____
a. concavity; short arc b. internal undercut; arc strikes c. burn-through; inclusions d. improper technique; contamination
The checkerboard pattern test is used to test ________
A) RAM B) FPLA C) EEPROM D) ROM