When rebar must be cut to close tolerances, the preferred tools are an abrasive (chop) saw or a(n) _____.
a. hacksaw
b. oxyacetylene torch
c. portable band saw
d. bolt cutter
c. portable band saw
You might also like to view...
Use the chart provided to determine the length of a 20-penny nail.
a. 10"
b. 8"
c. 4"
d. 6"
A fuel pump operates normally on initial start up. However, after a couple of minutes the fuel pump become snoisy and the vehicle has low power. What is a likely problem?
A.The fuel pump inlet filter plugs up with debris from the fuel tank. B.The fuel pump receives too much voltage. C.The exhaust system is plugged D.The fuel filter is plugged.
Use the accompanying figure. Angle A is 19o and angle B is 25o. Compute the angle of tilt and round to the nearest minute.
A. 30o06' B. 32o32' C. 33o33' D. 35o16'
The indoor dry bulb temperature for AHRI rating condition "A" is:
A) 68°F. B) 65°F. C) 75°F. D) 80°F.