In ladder diagrams, component symbols are placed:

A) In sequential order according to each component's model number.
B) By their function in the circuit.
C) By their actual physical location in the unit.
D) Only at the intersection points.


B

Trades & Technology

You might also like to view...

Acceptance testing calls for a maximum value of what percentage of the factory test voltage?

a. 80% b. 90% c. 100% d. 110%

Trades & Technology

If the square wave shown in Fig. 17.74(a) is applied to the circuit in Fig. 17.74(b), find the Fourier series for v?(t).

Trades & Technology

Two technicians are discussing a Hemi engine. Technician A says that a Hemi is an engine with a hemispherical shaped combustion chamber. Technician B says that all Hemi engines are cam-in-block designs. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

Technician A changes the position of a waste-spark ignition coil to diagnose an ignition misfire. Technician B says that a defective coil should cause problems on the cylinders it is connected to. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology