What is a component that varies or turns on and off the flow of current?
a. Conductor
b. Insulator
c. Load
d. Control device
d. Control device
You might also like to view...
In specifying the dimensions of a masonry unit, which dimension is stated last?
A) Length, L, of the unit B) Width, W, of the unit C) Height, H, of the unit
Which of the following is an acceptable working angle for a RWD driveshaft?
A) 6 degrees B) 1 degree C) 0 degrees D) None of these are correct.
If a 2.2 k? resistor, 10 k? resistor and 1.2 k? resistor are connected in parallel, the total resistance equals ________
A) 13.4 k? B) 1.2 k? C) 2.27 k? D) 721 ?
Isolating the break in a circuit by starting at a point where there is correct voltage, and moving one lead from point to point toward the nonfunctional load is called:
A) Running the rat. B) Hopscotching. C) Quantitative analysis. D) Shotgunning.