?What determines the amount of usable heat from storage?
A. ?average water temperature in the tank and lowest temperature at which the tank can supply heat to the load
B. ?water temperature at the top of the tank and tank pressure rating
C. ?minimum water temperature in the tank and the highest temperature at which the tank can supply heat to the load
D. ?amount of time between cycles of the heat source
Answer: A
You might also like to view...
Thrust bearings are being discussed. Technician A says the thrust bearing surface facing the front of the engine shows the most wear. Technician B says the most common cause of thrust bearing failure is too little clearance. Who is correct?
A. Technician A B. Technician B C. Both technicians D. Neither technician
Which of the following shop tools would most likely be required to remove old rubber bushings from an equalizing beam type suspension?
A. hammer and chisel B. oxy-acetylene cutting torch C. rosebud D. 50-ton hydraulic press
Use a(n) ________ to examine the pump and drive motor for unusually high temperatures
A) vernier caliper B) ammeter C) oscilloscope D) pyrometer
Technician A says that HSLA stands for high strength low alloy steel. Technician B says that hammers come in a variety of shapes and sizes, which allows them to be used for specific types of dent removal. Who is correct?
A. Technician A only B. Technician B only C. Both Technicians A and B D. Neither Technician A nor B