Explain how a municipal wastewater treatment system works
What will be an ideal response?
Raw sewage enters the wastewater treatment system by passing first through a coarse grid that filters out the largest
pieces of solid material. The water then moves into the primary treatment facility where floating debris and suspended
particles of solid material are filtered out or allowed to settle out. During this phase, biological decomposition
of the organic material begins. The partially treated wastewater moves into the secondary treatment facility
where biological decomposition continues and chemicals that encourage coagulation of smaller particles into larger
clumps are added. The water is allowed to move very slowly, during which time further biological decomposition
takes place and coagulated particles are allowed to settle or be filtered out. By the end of the second stage, at least
90 percent of all impurities have been removed. A final filtration at the end of the secondary treatment stage removes
most of the remaining solid matter. Finally, the partially purified water receives a tertiary treatment consisting of the
introduction of chemicals designed to neutralize most of the remaining biological and chemical contaminants. One
final filtration removes most of the remaining suspended solids. Water passing out of the tertiary treatment stage is
then reintroduced into the natural water cycle.
You might also like to view...
A module is also known as a ________
A) Terminator B) Resistor pack C) BUS D) Node
The ________ is a unit of electrical pressure
A) Volt B) Ohm C) Coulomb D) Ampere
Which of these ATC output devices provides a feedback signal to the electronic control module (ECM)?
A) Mode air door motor B) Blend door actuator C) Air inlet door vacuum motor D) Blower motor control
A dirty air filter would likely cause which of the following symptoms?
A) Low suction pressure B) High superheat C) Low subcooling D) High condenser pressure