Answer the following statement(s) true (T) or false (F)
1. Where a feature of size datum feature is referenced as a primary datum feature at MMC, the datum feature simulator is a fixed-size.
2. Devices that are fixed in size, such as a precision hole, width, or pin, may be used as the datum feature simulator.
3. When referencing a planar surface as a primary datum feature, a diameter as a secondary datum feature MMB, and a width as a tertiary datum feature MMB, the part will have a minimum of four-point contact with the primary datum feature simulator.
4. Where a coaxial datum feature is referenced at MMB, two degrees of freedom are constrained.
5. Where a pattern of holes is used as a datum feature, the spacing between the holes should be defined.
1. F
2. T
3. F
4. F
5. T
You might also like to view...
Write the matrix form of the mesh equations again by using the following formulas:
rii = resistances around loop i
ri j = ? resistances shared by loops i and j
Vi = source voltages around loop i
For the circuit of Figure P3.19, write the mesh equations in matrix form. Notice the form of the [R] and [V] matrices in [R] [I ] = [V], where
There are three types of workers’ compensation insurance: state funds, private insurance, and self-insurance.
There is no difference between OVE headers and conventional framing using same-size headers
Indicate whether the statement is true or false
Not drinking enough water is one cause of poor nutrition.
Answer the following statement true (T) or false (F)