The power wire for the condensing unit is sized:
A) By the minimum circuit ampacity (MCA) shown on the name plate.
B) By the maximum overcurrent protection (MOP) shown on the nameplate.
C) The same wire gauge as the wires inside the unit.
D) At 115% of the minimum circuit ampacity shown on the nameplate.
A
You might also like to view...
Five plates are stacked and weighed. Their total weight is 415 pounds. What is the average weight of each plate, in pounds?
What will be an ideal response?
Technician A says that for each pound of pressure on the cooling system, the boiling point raises one degree Fahrenheit. Technician B says engine rebuilders epoxy heat tabs to the cylinder heads to protect against dishonest warranty claims. Who is correct?
A. Technician A B. Technician B C. Both technicians D. Neither technician
Which of these core materials is most common in softwood plywood?
A) Veneer B) Particleboard C) Lumber D) Fiberboard
Any time a corded power tool is used on a job site, it must be plugged into a _____
a. ground fault circuit interrupter b. circuit breaker c. panelboard d. surge protector