____ strength is a measure of how well a part can withstand forces acting to cut or slice it apart.

A. Tensile
B. Compressive
C. Shear
D. Torsional


Answer: C

Trades & Technology

You might also like to view...

When the certificate of final completion is issued, what is the project ready for?

a. inspection c. bonding b. sale d. occupancy

Trades & Technology

The most accurate method of charging a small appliance that holds less than a lb of refrigerant is to add:

A) Vapor into the low side with the system operating while checking the compressor amp draw. B) Vapor with the system not operating up to a specified static pressure at a specified ambient temperature. C) Liquid into the system with the system off until the liquid stops going in. D) Liquid into the system until the pressure equals the saturation pressure and temperature.

Trades & Technology

A vehicle with an electronic ignition (EI) system has a loss of power with no engine misfiring. Technician A that says the base ignition timing may be late. Technician B says that the exhaust system may be restricted. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Trades & Technology

The output of a pneumatic transmitter produces ____________________ psi when the zero adjustment of a calibration procedure is performed.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology